Tube Fitting
$10.55
NO. 20, Tube Fitting, Sold Individually, color may vary
For use on the Original Electric Seam Phantom to connect the rub plate water supply tube to the valve
Not for use on Seam Phantom 2.0
Related Products
Adjustment Nut
Replacement adjustment nut for the Seam Phantom®.
- Solid brass nut for all Original Seam Phantoms®
- Anti-rattle red plastic with brass insert for all Seam Phantom® 2.0
White Rub Plate – Electric
This rub plate is intended to be used with the Original Electric Seam Phantom. Also known as “The Shoe”. This version has extra holes and channels to distribute the water routed through the rub plate on the original design.
Not for use on Seam Phantom 2.0
Glide Guide, 92″
92″ Glide Guide Rail for use with the ORIGINAL Seam Phantom. Can be used to produce seams up to 86″ long. This was our preferred guide rail design for over a decade. Also available in 48″ and 72″
*Note: Does not work with Seam Phantom 2.0
*Note: This item is considered “oversize” by FedEx. The shipping cost will include additional fees for “oversize” and handling.
SL3® 3 Inch Rigid Turbo Abrasive, 150 Grit
3″, rigid backed, turbo abrasive
- 150 grit – Popular replacement turbo for the Seam Phantom®
- Wet use only
- 3 1/8″ actual outside diameter
- Locks into the SL3® Snail Lock Adapter
- Maximum RPM 4000
Placard Kit
No. 32 & No. 33, Safety Placard Kit
Sold as a kit with (1) #32 Eye Protection placard and (1) #33 GFCI Protection placard
Universal replacement for all Seam Phantoms and Sink BULL.
*Updated* Spray Shield
No. 105. Stainless steel spray shield for the Original Electric Seam Phantom® . This replaces the old black aluminum spray shield.
Not for use on Seam Phantom 2.0.
Metric Screw and Shim Washer Kits
SCREW KIT 27 – Contains (4) #27 screws and (4) #31 shim washers. These screws are used to attach the Original Seam Phantom to a Makita Grinder or air polisher adapter. The shim washers are used to fine-tune the grinding angle.
SCREW KIT 327 – Contains (4) #327 screws and (4) #31 shim washers. These are the longer screws used to attach a modified Seam Phantom to a Makita Center Water Polisher (PW5001C) through an adapter. The shim washers are used to fine-tune the grinding angle.
Neither of these kits is used for Seam Phantom 2.0
Arbor Spacer
Arbor Spacer for use with all Electric Seam Phantoms®. Installed between the red snail lock adapter and the grinder to locate the turbo at the most useful position. Works with 5/8-11 or M14 threads.
- 0.19″ thick for all original Seam Phantoms® and most Seam Phantom® 2.0 versions
- 0.32″ thick for Seam Phantom® 2.0 with Metabo grinder ONLY