1″ Rapid Z™-DRUM – Coarse
$139.95 (MSRP) AVAILABLE THROUGH A STOCKING DISTRIBUTOR ONLY.
A 1″ diameter vacuum brazed drum wheel, specifically designed for use with the Sink BULL™. This is the bit you need to clean out the tight corner radius on square sinks. Available in two grits with a top bearing to ride along the template. The coarse grit cleans up the extra material left by the Rapid Z™-CUT and the fine grit further smooths the surface leaving it ready to polish. The height matches the Rapid Z™-CUT so height adjustments on the Sink BULL are not required between bits. It is center water feed compatible (note: the Sink BULL™ does not use center water feed).
- Fits 5/8-11 arbor threads (M14 version available)
- Height matched to the Rapid Z™-CUT
- Center water feed compatible
- Maximum RPM 8500
- Coarse grit (30/40 grit)
Related Products
3″ Rapid Z™-CUT Outer Ring
No. 107, Outer bearing ring
Large outer ring used on the Rapid Z™-CUT with new blades
Sink BULL™ Height Adjustment Handle Only
Replacement Sink BULL™ height adjustment handle.
- Fits all Sink BULLs
3″ Rapid Z™-DRUM Replacement Bearing
No. 230, Replacement Bearing for 3″ Rapid ZTM-DRUM
3″ Rapid Z™-DRUM Arbor Key
No. 240, Key for 3″ Rapid ZTM-DRUM
Replacement key for the Rapid ZTM-DRUM
Rapid-Z™ Bolt and Washer Kit
No. 21 & No. 22 Bolt Kit for Rapid Z™-CUT and Rapid Z™-DRUM
Sold as a kit with (1) #21 bolt and (1) #22 washer
Used to retain the blades and drum wheels on the Rapid Z™-CUT and Rapid Z™-DRUMS
Sink BULL™ – UPGRADED Replacement Grips
Tired of your Sink BULL™ grips sliding around on the bar? We were too!!! After trying every type of grip adhesive we could find, we just sourced better grips. We’ve been using them for a couple years and our fabricators love them. These upgraded replacement grips have the extra screw length required to fit the original Sink BULL™.
- Sold as a pair
- Fits the Original Sink BULL™
- Does NOT fit the New Sink BULL™LT
3″ Rapid Z™-CUT Replacement Blades
$9.45 (MSRP) AVAILABLE THROUGH A STOCKING DISTRIBUTOR ONLY.
Replacement blade for the Rapid Z™-CUT. Watch our video below on how to change the blades.
- 3″ diameter x .08 thick x 7/8 arbor hole
- Maximum RPM 12,000
- Price listed is for one blade
- Rapid Z™-CUT WITH TEMPLATE BEARING uses 12 replacement blades
- Rapid Z™-CUT NO BEARING uses 17 replacement blades
Click Here to Watch Our Rapid Z™ Blade Replacement Video!