Ultra Guide, 46″
$265.00
Designed from the ground-up for use with the Seam Phantom® 2.0. This guide provides next-level accuracy when producing superior seams in stone slab material.
This is the guide provided with every new Seam Phantom® 2.0
*Note: This guide will not work with the original Seam Phantom unless you change out the wheels
Related Products
Updated Wheel Axle Assembly
Updated version of the GWAF.
Sold as a kit (1) #215 Brass Axle, (1) #17 Bearing Shim, (1) #216 Screw, and (1) #217 Washer.
Two Axle assemblies required per Seam Phantom
Universal Replacement for ALL Seam Phantoms.
SL3® 3 Inch Rigid Turbo Abrasive, 300 Grit
3″, rigid backed, turbo abrasive
- 300 grit – Popular replacement turbo for the Seam Phantom®
- Wet use only
- 3 1/8″ actual outside diameter
- Locks into the SL3® Snail Lock Adapter
- Maximum RPM 4000
SL3® Cup Wheel – 2 Inch
2″ cup Wheel for use with the Electric or Air Seam Phantom to create the undercut or back bevel.
- Locks into the SL3® Snail Lock Adapter
- Maximum RPM 10,000
Hose Assembly
No. 115. Hose assembly for Seam Phantom® & Sink BULL™
Sold as a complete 6′ assembly with a brass threaded male fitting to attach to the valve and a brass female garden hose fitting on the opposite end. All hose assemblies will be supplied with a straight fitting to attach to the valve instead of the old 45 degree fitting.
For use on all Electric Seam Phantoms® that require external water feed plus the Sink BULL™.
Valve Bracket Assembly
NO LONGER AVAILABLE
No. 117, SOLD AS AN ASSEMBLY, INCLUDES 2 SET SCREWS #19
Grip Knob
Upper grip knob for the Seam Phantom
|
Set Screws
NO. 19. Sold in a pack of 2.
Set Screws for the original black valve bracket used on the original electric Seam Phantoms®
Not for use on Seam Phantom 2.0
Metric Screw and Shim Washer Kits
SCREW KIT 27 – Contains (4) #27 screws and (4) #31 shim washers. These screws are used to attach the Original Seam Phantom to a Makita Grinder or air polisher adapter. The shim washers are used to fine-tune the grinding angle.
SCREW KIT 327 – Contains (4) #327 screws and (4) #31 shim washers. These are the longer screws used to attach a modified Seam Phantom to a Makita Center Water Polisher (PW5001C) through an adapter. The shim washers are used to fine-tune the grinding angle.
Neither of these kits is used for Seam Phantom 2.0