Metric Screw and Shim Washer
$8.65
No. 27 & No. 31, Original Seam Phantom attachment screws
Sold as a kit with (4) #27 screws and (4) #31 shim washers
Screws used to attach the Original Seam Phantom to a Makita Grinder or air polisher adapter, and Shim washers used to fine-tune the grinding angle
Not for use with Seam Phantom 2.0
Related Products
Hose Assembly
No. 115. Hose assembly for Seam Phantom
Sold as a complete 6′ assembly with a brass threaded male fitting to attach to the valve and a brass female garden hose fitting on the opposite end. All hose assemblies will be supplied with a straight fitting to attach to the valve instead of the old 45 degree fitting.
For use on all Electric Seam Phantoms that require external water feed.
Updated Wheel Axle Assembly
Updated version of the GWAF.
Sold as a kit (1) #215 Brass Axle, (1) #17 Bearing Shim, (1) #216 Screw, and (1) #217 Washer.
Two Axle assemblies required per Seam Phantom
Universal Replacement for ALL Seam Phantoms.
Grip Knob
Upper grip knob for the Seam Phantom
|
Glide Guide, 72″
72″ Glide Guide Rail for use with the ORIGINAL Seam Phantom. Can be used to produce seams up to 66″ long. This was our preferred guide rail design for over a decade. Also available in 48″ and 92″
*Note: Does not work with Seam Phantom 2.0
*Note: This item is considered “oversize” by FedEx. The shipping cost will include additional fees for “oversize” and handling.
Gauge Blocks, Pair, Replacement
Used with the Seam Phantom to set the proper offset distance before clamping the Guide. Supplied as a pair with all Seam Phantom® packages
- Silver aluminum version for all Original Seam Phantoms® and the Glide Guide
- Red plastic version for Seam Phantom® 2.0 and the Ultra Guide
Screws
No. 1, Screws
Sold in a pack of (10) #1 screws
Attaches the white rub plate and valve bracket on the original Seam Phantom®. Also used for the rub plates, valve bracket and spray shield on Seam Phantom® 2.0 LT & DLX versions. Buy multiple packs if you require more than 10 screws.
SL3® Cup Wheel – 2 Inch
2″ cup Wheel for use with the Electric or Air Seam Phantom to create the undercut or back bevel.
- Locks into the SL3® Snail Lock Adapter
- Maximum RPM 10,000
Glide Guide, 92″
92″ Glide Guide Rail for use with the ORIGINAL Seam Phantom. Can be used to produce seams up to 86″ long. This was our preferred guide rail design for over a decade. Also available in 48″ and 72″
*Note: Does not work with Seam Phantom 2.0
*Note: This item is considered “oversize” by FedEx. The shipping cost will include additional fees for “oversize” and handling.