Sink BULL™ - UPGRADED Replacement Grips 
3″ Rapid Z™-DRUM Replacement – Coarse
$129.95
Replacement drum for the 3″ Rapid Z™-DRUM. Vacuum brazed diamond abrasive can be flipped on the arbor to gain extra life.
- Maximum RPM 8500
- Reversible
- Coarse Grit (30/40 grit)
Related Products
Multi-Function Wrench – Sink BULL LT
This Multi-Function Wrench is designed for use with The Sink BULL™LT. The Wrench fits all 3″ and 1″ Rapid-Z Abrasives. It is also used as a gauge block to set the initial grinding height on the Sink BULL™LT.
3″ Rapid Z™-DRUM Replacement Bearing
No. 230, Replacement Bearing for 3″ Rapid ZTM-DRUM
Rapid Z™-CUT Screws
No. 23, Screws for bearing ring
Sold in a pack of (4) #23 screws
Replacement screws used to attach the large outer bearing ring on a Rapid Z™-CUT
Rapid Z™-CUT Blade Spacer
No. 111, Blade spacer, Sold Individually
This is the spacer between the blades on a Rapid Z™-CUT
13 required for the Rapid Z™-CUT with top bearing
17 required for the Rapid Z™-CUT NO bearing
3″ Rapid Z™-CUT Inner Ring
No 105, Inner bearing ring
Inner ring that is pressed onto the template follower bearing on a Rapid Z™-CUT
Bearing sold separately
1″ Rapid Z™-DRUM – Coarse
A 1″ diameter vacuum brazed drum wheel, specifically designed for use with the Sink BULL™. This is the bit you need to clean out the tight corner radius on square sinks. Available in two grits with a top bearing to ride along the template. The coarse grit cleans up the extra material left by the Rapid Z™-CUT and the fine grit further smooths the surface leaving it ready to polish. The height matches the Rapid Z™-CUT so height adjustments on the Sink BULL are not required between bits. It is center water feed compatible (note: the Sink BULL™ does not use center water feed).
- Fits 5/8-11 arbor threads (M14 version available)
- Height matched to the Rapid Z™-CUT
- Center water feed compatible
- Maximum RPM 8500
- Coarse grit (30/40 grit)
1″ Rapid Z™-DRUM – Fine
A 1″ diameter vacuum brazed drum wheel, specifically designed for use with the Sink BULL™. This is the bit you need to clean out the tight corner radius on square sinks. Available in two grits with a top bearing to ride along the template. The coarse grit cleans up the extra material left by the Rapid Z™-CUT and the fine grit further smooths the surface leaving it ready to polish. The height matches the Rapid Z™-CUT so height adjustments on the Sink BULL are not required between bits. It is center water feed compatible (note: the Sink BULL™ does not use center water feed).
- Fits 5/8-11 arbor threads (M14 version available)
- Height matched to the Rapid Z™-CUT
- Center water feed compatible
- Maximum RPM 8500
- Fine Grit (120/150 grit)
3″ Rapid Z™-DRUM Replacement – Fine
Replacement drum for the 3″ Rapid Z™-DRUM. Vacuum brazed diamond abrasive can be flipped on the arbor to gain extra life.
- Maximum RPM 8500
- Reversible
- Fine Grit (120/150 grit)