Sink BULL™LT Complete Kit 
3″ Rapid Z™-DRUM Replacement – Fine
$129.95
Replacement drum for the 3″ Rapid Z™-DRUM. Vacuum brazed diamond abrasive can be flipped on the arbor to gain extra life.
- Maximum RPM 8500
- Reversible
- Fine Grit (120/150 grit)
Related Products
White Rub Plate – Original Sink BULL™
This is a replacement white plastic rub plate for the lower surface of the original Sink BULL™. This kit includes 6 extra attachment screws.
- Fits the original Sink BULL™
- Does NOT fit the New Sink BULL™LT
Sink BULL™ Height Adjustment Handle Kit
Replacement Sink BULL™ height adjustment handle includes bolt and washer.
- Universal replacement for Sink BULL and Sink BULL LT
- Sold as a kit
3″ Rapid Z™-CUT Outer Ring
No. 107, Outer bearing ring
Large outer ring used on the Rapid Z™-CUT with new blades
Rapid Z-CUT Screws Sold Separately.
3″ Rapid Z™-DRUM Replacement – Coarse
Replacement drum for the 3″ Rapid Z™-DRUM. Vacuum brazed diamond abrasive can be flipped on the arbor to gain extra life.
- Maximum RPM 8500
- Reversible
- Coarse Grit (30/40 grit)
Multi-Function Wrench – Sink BULL LT
This Multi-Function Wrench is designed for use with The Sink BULL™LT. The Wrench fits all 3″ and 1″ Rapid-Z Abrasives. It is also used as a gauge block to set the initial grinding height on the Sink BULL™LT.
1″ Rapid Z™-DRUM – Fine
A 1″ diameter vacuum brazed drum wheel, specifically designed for use with the Sink BULL™. This is the bit you need to clean out the tight corner radius on square sinks. Available in two grits with a top bearing to ride along the template. The coarse grit cleans up the extra material left by the Rapid Z™-CUT and the fine grit further smooths the surface leaving it ready to polish. The height matches the Rapid Z™-CUT so height adjustments on the Sink BULL are not required between bits. It is center water feed compatible (note: the Sink BULL™ does not use center water feed).
- Fits 5/8-11 arbor threads (M14 version available)
- Height matched to the Rapid Z™-CUT
- Center water feed compatible
- Maximum RPM 8500
- Fine Grit (120/150 grit)
3″ Rapid Z™-CUT Inner Ring
No 105, Inner bearing ring
Inner ring that is pressed onto the template follower bearing on a Rapid Z™-CUT
Bearing sold separately
Rapid-Z™ Bolt and Washer Kit
No. 21 & No. 22 Bolt Kit for Rapid Z™-CUT and Rapid Z™-DRUM
Sold as a kit with (1) #21 bolt and (1) #22 washer
Used to retain the blades and drum wheels on the Rapid Z™-CUT and Rapid Z™-DRUMS