Placard Kit
$8.85
No. 32 & No. 33, Safety Placard Kit
Sold as a kit with (1) #32 Eye Protection placard and (1) #33 GFCI Protection placard
Universal replacement for all Seam Phantoms and Sink BULL.
Related Products
Hose Assembly
No. 115. Hose assembly for Seam Phantom® & Sink BULL™
Sold as a complete 6′ assembly with a brass threaded male fitting to attach to the valve and a brass female garden hose fitting on the opposite end. All hose assemblies will be supplied with a straight fitting to attach to the valve instead of the old 45 degree fitting.
For use on all Electric Seam Phantoms® that require external water feed plus the Sink BULL™.
SL3® 3 Inch Rigid Turbo Abrasive, 150 Grit
3″, rigid backed, turbo abrasive
- 150 grit – Popular replacement turbo for the Seam Phantom®
- Wet use only
- 3 1/8″ actual outside diameter
- Locks into the SL3® Snail Lock Adapter
- Maximum RPM 4000
SL3® 3 Inch Rigid Turbo Abrasive, 300 Grit
3″, rigid backed, turbo abrasive
- 300 grit – Popular replacement turbo for the Seam Phantom®
- Wet use only
- 3 1/8″ actual outside diameter
- Locks into the SL3® Snail Lock Adapter
- Maximum RPM 4000
Ultra Guide, 46″
Designed from the ground-up for use with the Seam Phantom® 2.0. This guide provides next-level accuracy when producing superior seams in stone slab material.
This is the guide provided with every new Seam Phantom® 2.0
*Note: This guide will not work with the original Seam Phantom unless you change out the wheels
Glide Guide, 92″
92″ Glide Guide Rail for use with the ORIGINAL Seam Phantom. Can be used to produce seams up to 86″ long. This was our preferred guide rail design for over a decade. Also available in 48″ and 72″
*Note: Does not work with Seam Phantom 2.0
*Note: This item is considered “oversize” by FedEx. The shipping cost will include additional fees for “oversize” and handling.
Metric Screw and Shim Washer Kits
SCREW KIT 27 – Contains (4) #27 screws and (4) #31 shim washers. These screws are used to attach the Original Seam Phantom to a Makita Grinder or air polisher adapter. The shim washers are used to fine-tune the grinding angle.
SCREW KIT 327 – Contains (4) #327 screws and (4) #31 shim washers. These are the longer screws used to attach a modified Seam Phantom to a Makita Center Water Polisher (PW5001C) through an adapter. The shim washers are used to fine-tune the grinding angle.
Neither of these kits is used for Seam Phantom 2.0
Grip Knob
Upper grip knob for the Seam Phantom
|
Updated Wheel Axle Assembly
Updated version of the GWAF.
Sold as a kit (1) #215 Brass Axle, (1) #17 Bearing Shim, (1) #216 Screw, and (1) #217 Washer.
Two Axle assemblies required per Seam Phantom
Universal Replacement for ALL Seam Phantoms.