*Updated* Spray Shield
$20.30
No. 105. Stainless steel spray shield for the Original Electric Seam Phantom® . This replaces the old black aluminum spray shield.
Not for use on Seam Phantom 2.0.
Related Products
Set Screws
NO. 19. Sold in a pack of 2.
Set Screws for the original black valve bracket used on the original electric Seam Phantoms®
Not for use on Seam Phantom 2.0
SL3® 3 Inch Rigid Turbo Abrasive, 150 Grit
3″, rigid backed, turbo abrasive
- 150 grit – Popular replacement turbo for the Seam Phantom®
- Wet use only
- 3 1/8″ actual outside diameter
- Locks into the SL3® Snail Lock Adapter
- Maximum RPM 4000
SL3® Snail Lock Adapter
- Fits 5/8-11 Threads
- Balanced to eliminate vibration
- Snail lock attachment grips all SL3® components
Also available in M14 thread.
Metric Screw and Shim Washer Kits
SCREW KIT 27 – Contains (4) #27 screws and (4) #31 shim washers. These screws are used to attach the Original Seam Phantom to a Makita Grinder or air polisher adapter. The shim washers are used to fine-tune the grinding angle.
SCREW KIT 327 – Contains (4) #327 screws and (4) #31 shim washers. These are the longer screws used to attach a modified Seam Phantom to a Makita Center Water Polisher (PW5001C) through an adapter. The shim washers are used to fine-tune the grinding angle.
Neither of these kits is used for Seam Phantom 2.0
Updated Wheel Axle Assembly
Updated version of the GWAF.
Sold as a kit (1) #215 Brass Axle, (1) #17 Bearing Shim, (1) #216 Screw, and (1) #217 Washer.
Two Axle assemblies required per Seam Phantom
Universal Replacement for ALL Seam Phantoms.
Ultra Guide, 46″
Designed from the ground-up for use with the Seam Phantom® 2.0. This guide provides next-level accuracy when producing superior seams in stone slab material.
This is the guide provided with every new Seam Phantom® 2.0
*Note: This guide will not work with the original Seam Phantom unless you change out the wheels
Arbor Spacer
Arbor Spacer for use with all Electric Seam Phantoms®. Installed between the red snail lock adapter and the grinder to locate the turbo at the most useful position. Works with 5/8-11 or M14 threads.
- 0.19″ thick for all original Seam Phantoms® and most Seam Phantom® 2.0 versions
- 0.32″ thick for Seam Phantom® 2.0 with Metabo grinder ONLY
Placard Kit
No. 32 & No. 33, Safety Placard Kit
Sold as a kit with (1) #32 Eye Protection placard and (1) #33 GFCI Protection placard
Universal replacement for all Seam Phantoms and Sink BULL.